BlueOnyx 5209R manual install
Please note: The recommended method to install BlueOnyx is to use the ISO image.
However: If you cannot do so, then it is possible to install BlueOnyx 5209R manually.
This instructions are for installing BlueOnyx 5209R on CentOS 7, Scientific Linux 7 or RHEL 7.
1.) Pre-installed CentOS 7, Scientific Linux 7 or RHEL 7 server (minimal install).
2.) Partitions & Filesystems: The partition layout doesn't matter. But if possible set up a separate /home partition, which has some benefits. But we can do without separate /home. But please make sure to use the EXT4 or EXT3 filesystems. XFS and BTRFS use different disk quota systems which are not compatible with BlueOnyx.
2.) "root" access
3.) Working network connection and pre-configured network settings.
4.) SELinux must be disabled (see: /etc/selinux/config, SELINUX=disabled)
Log in as "root" by SSH or the console. Run this command to install the BlueOnyx 5209R YUM configuration file:
rpm -hUv http://devel.blueonyx.it/pub/5209R.rpm
Then run this command to install BlueOnyx 5209R and all its dependencies:
yum groupinstall blueonyx
Let it grab and install the stuff. It'll be around 800-1200 RPMs. That kind of depends on your base install. This will take a while to finish.
After the RPMs have been installed, check with "ps axf" to see if all the install related processes are finished. There might still some CCEd handlers/constructors working in the background. Give them time to finish.
Then reboot. DO NOT SKIP THE REBOOT!!!
This reboot is important, as it will be used to turn SELinux and the service Firewalld off and it will enable disk quota for /home (if present) or / if there is no separate /home partition. Additionally it will automatically create the user "admin", which you need to login to the GUI.
The reboot will be quick, as Systemd fires up the services in parallel as fast as it can. So when you get a shell it doesn't mean that the system is finished booting OR has finished the initial configuration. Please watch the process list with "ps axf" or top until the system has stabilized itself.
Now run this script:
DO NOT SKIP THIS STEP! Even if your network is still working! This is needed to get the network details into CODB and to restart some services.
Once that's done you might be able to reach the GUI by pointing your browser to port 444 (GUI via HTTP) or port 81 (GUI via HTTPS).
This install procedure only works for BlueOnyx 5209R. It is by far the cleanest BlueOnyx version as far as he install is concerned and the RPMs and their post install scripts do a lot of setup related tasks which the same RPMs for older BlueOnyx versions didn't.
If you have any questions about or problems with the install procedure, then please ask on the BlueOnyx mailing list.